sdipesh182 sdipesh182

23-05-2023
Engineering

contestada

calculate the time required to turn a stepped shaft to the dimensions shown in below figure. From MS stock of 4cm diameter. Neglect Facing and set up Time. The depth of cut should not exceed 0.25cm. Assume the cutting speed to be 20m/min and Feed to be 0.3 mm/revolution For each cut.

calculate the time required to turn a stepped shaft to the dimensions shown in below figure From MS stock of 4cm diameter Neglect Facing and set up Time The dep class=

Respuesta :

Otras preguntas

The United States became involved in the war with Germany because

GiVe one example of when you would make a frequency table to solve a problem

When exercising, you should (A.) plan to take in extra water. B. avoid wasting time with a warm-up. C. work through any pain that you experience. D. plan to tak

Write 4 13/20 as a decimal.

an unidentified compound contains only oxygen and hydrogen. is it organic?

A pollen grain contains the male gametophyte, sperm, which is ____. A. a spermatangium B. a microsporocyte C. haploid D. a gymnosperm

Which of these is a true statement about anthropologists?

Why did most Irish Americans favor neutrality?

Wings and flying are often a metaphor for what?

Lamarck wrote an important book talking about A. the old age of Earth. B. how organisms could change. C. the movement of the continents. D. that fossils were ex